Español   English  
editecnos sistemas fachadas pegadas ceramica fpc

Concealed anchorage placement system

Editecnos manufactures and sells the anchorages.

With this system, the ceramic parts are machined at their vertices. This is where they are secured to the vertical profiles with clamps that remain concealed in the machining of the part. A fibreglass mesh is adhered to the rear of the ceramic parts for safety purposes in order to prevent them from becoming detached in the case of breakage.

  1. Placement of the stainless steel start and end anchorage (EA) to the support by boring a 4 mm diameter hole. The plug and screws are inserted using a screwdriver.
    editecnos
  2. Positioning of porcelain stoneware tiles in fine layer with 8 mm tile-to-tile joint. With improved cementitious adhesive, type C2 – TE according to European regulation EN 12004 and type S1 according to EN 12002. The adhesive will be applied via the buttering and floating technique, whenever the format is greater than 35 x 35 cm.
    editecnos
  3. Placement of the anchorage in the tile groove
    editecnos
  1. Placement of the upper tile on the previous one, after positioning the 8 mm separating crosspiece.
    editecnos
  2. Fixation of the intermediate anchorage to the support by boring a 4 mm diameter hole. The plug and the screw will be inserted using a screwdriver and at least 24 hours after the placement of the tile, in order not to jeopardise its adherence.
    editecnos
  3. Grouting of the ceramic cladding with mortar type CG 2 according to EN 13888 once the mechanical anchorage has already been secured.
    editecnos
  4. Placement of the end anchorage (ET) securing the clamp, as described in figure 1. Then place the ceramic tile and once in place, slide the anchorage downwards as shown in figure 2.
    editecnos
© Editecnos. C/ Atzeneta Naves 6-7 - 12550 Almazora - Spain - Telf. +34 964 100 506 | LEGAL NOTE | Design web: Idea Publicidad