Español   English  
editecnos sistemas fachadas pegadas ceramica fpc

Visible anchorage placement system

The ceramic parts are fastened to the vertical profile with anchorages that remain visible, which secure the part. Therefore, in this case, the part is not machined. A fibreglass mesh is adhered to the rear of the ceramic parts for safety purposes in order to prevent them from becoming detached in the case of breakage.

  1. Placement of the stainless steel start and end clamp (EA) to the support by boring a 4 mm diameter hole. The plug and stainless steel screw secure the anchorage.
    editecnos
  2. Placement of porcelain stoneware tiles in fine layer and open 8 mm joint, with improved cementitious adhesive, type C2TE S1 according to UNE EN 12004. The adhesive will be applied via the buttering and floating technique.
    editecnos
  3. Placement of the upper tile on the previous one, after positioning the 8 mm separating crosspiece.
    editecnos
  1. Placement and fixation of the clamp to the support by boring a 4 mm diameter hole. The plug and the screw will be inserted at least 24 hours after the placement of the tile, in order not to jeopardise its adherence.
    editecnos
  2. Grouting of the ceramic cladding with cementitious mortar type CG2 according to UNE EN 13888 once the mechanical anchorage has already been secured.
    editecnos
  3. Placement of the end ET clamp securing the anchorage, as described in figure 1. Then place the ceramic tile and once in place, slide the clamp downwards as shown in figure 2.
    editecnos
© Editecnos. C/ Atzeneta Naves 6-7 - 12550 Almazora - Spain - Telf. +34 964 100 506 | LEGAL NOTE | Design web: Idea Publicidad